Pipe Dreams: An Odor Control System Built to Last
AOC and ECS Environmental Solutions worked together to create an integral part of the city of Austin’s complex wastewater infrastructure project. The new 3.9-mile waste-water tunnel increases capacity for the downtown district and facilitates residential and business growth in the area. An important part of the project is an odor control system.
ECS Environmental Solutions provided the odor control equipment and relied on AOC’s Vipel K022 resin for more than 1,000 feet of fiberglass ductwork and additional accessories. The ductwork ranges in size from 12 inches to 72 inches in diameter. Approximately half of the ductwork is buried below ground and had to be able to withstand thousands of pounds of high-density traffic driving over the site. Additional elements of the project include field joint kits, flexible connectors, control and back-draft dampers, bolt gaskets and two fiberglass exhaust fans rated at 40,000 cubic feet per minute (CFM).
Long Life Cycle
ECS manufactured all of the fiberglass ductwork using a state-of-the-art computerized filament winder. The fiber was impregnated Vipel® K022 corrosion-resistant vinyl ester resin, which is ideally suited for filament winding. “The K022 resin was the best choice for this project,” says Jeff Jones, president of ECS. “Some of the gases in the air stream are corrosive – hydrogen sulfide and ammonia. There’s also sulfuric acid. Pipes built with this resin are very resistant to what goes in them: They will not easily corrode.”
To help ease installation, ECS prefabricated and sub-assembled the duct system at its facility, then shipped it to Austin about an hour away. A field crew of five from ECS traveled to the construction site and handled all the field layup. That’s when AOC’s service became invaluable, says Jones.
“We work in a controlled environment in the shop, but in the field you are open to the elements,” says Jones. “Some of the days we were in Austin were cold and others were really hot. We had to adjust promotion levels and add inhibitors to work with the resin long enough to do a quality job under tough conditions.” AOC offered technical assistance that helped ECS re-formulate the resin and meet the demands of this material-intensive project. “With the long runs and thick pipes, we went through material much faster than normal, and AOC was very good at meeting this fluctuation in demand,” says Jones. “If we ran out of resin on this job, it would have put the project to a halt. AOC got materials here when we needed them. They were fantastic to work with!
About ECS Environmental Solutions
ECS, Belton, Texas, is the nation’s leading supplier of odor control equipment and accessories. A division of family-owned TexGlass Industries, ECS designs and manufactures products at its 100,000-square-foot facility in central Texas. Its odor control systems have been installed across North America. For more information, visit www. ecs-env.com for environmen-tal solutions or www.ecs-frp.com for manufactured offerings.
Read the case history
Read about the history and detailed information about this caseDownload Case History